United Vision Solutions Eagle Vision EV3000-D User Manual page 26

EV3000-D manual
Command
49 Camera Command
Power
on at
EV3000-D
camera 2
Response
Description
50 Camera Command
Power
off at
EV3000-D
camera 2
Response
Description
51 Initialize Command
PAN/TI
LT
EV3000-D
Response
Description
Equipment described herein may require US Government authorization for export purposes. Diversion contrary to US law
is prohibited. ©2008 United Vision solutions, Co., Specifications are subject to change. Check website:
Byte1 Byte2
FFh Receiver
ID
Receiver ID=00h~FEh, Camera 2 is Thermal Camera (Clear Bit 6 of
Byte3 to Select Camera 2.) DC 12V IR power supply of Thermal
camera Will be electrically Turned On by EV3000-D Receiver
Without any command sending to thermal camera
DC12V Defroster supply will always be turned on state.
FFh Receiver
ID
Receiver ID=00h~FEh, Camera 2 is Thermal Camera (Clear Bit 6 of
Byte3 to Select Camera 2.) DC 12V IR power supply of Thermal
camera Will be electrically Turned Off by EV3000-D Receiver
without any command sending to thermal camera. But DC12V
Defroster supply will always be turned on state.
FFh Receiver
ID
Receiver ID=00h~FEh, Pan/Tilt will go to Preset position No."0"
which is stored in EEPROM of EV3000-D receiver when
manufactured in factory.
www.unitedvisionsolutions.com
Byte3 Byte4 Byte5
00h 00h
09h
00h 00h
0Bh
00h 00h
0Fh
Byte6 Byte7
Checksum
0Ch
(default state).But
Checksum
0Ch
Checksum
00h