Cleaning And Maintenance; Troubleshooting - Dometic CF 11 Operating Manual

CoolFreeze
7

Cleaning and maintenance

!
WARNING!
Always disconnect the device from the power supply before you clean
and service it.
A
NOTICE! Risk of damage
•
Never clean the cooler under running water or in dish water.
•
Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
8

Troubleshooting

Problem
Device does not function,
"POWER" LED does not light
up.
CF11, CF26: The device
does not cool (plug is
inserted, "POWER" LED is
lit).
CF11, CF16: The device
does not cool (plug is
inserted, "POWER" LED
flashes, display is empty).
EN
Possible cause
No voltage is flowing
from the DC power
socket in your
vehicle.
No voltage present in
the AC voltage
socket.
The device fuse is
defective.
The integrated mains
adapter is defective.
Defective
compressor.
The voltage is too low
at the 12/24 V
socket.
Cleaning and maintenance
Suggested remedy
The ignition must be switched on in
most vehicles to supply current to
the on-board power socket.
Try using another plug socket.
Replace the device fuse, see chapter
"Replacing the AC fuse" on page 16.
This can only be repaired by an
authorised repair centre.
This can only be repaired by an
authorised repair centre.
Check the battery and charge if
necessary.
Check the cables and connections.
17