With Floor Nozzle - Shark Navigator NV351 Owner's Manual

Above-Floor Cleaning
Release suction for
a
easier push & pull
on thick carpets and
Fig. 15
Suction
area rugs.
Release Collar
CLEAN ABOVE THE FLOOR IN UPRIGHT VAC OR
DETACHABLE CANISTER MODE
1
Press the handle release button and pull the handle up
or press the extension wand release button and pull the
extension wand up.
2
Attach desired accessory onto the end of either the
extension wand or the handle. (Fig. 15)
3 Your vacuum has tremendous suction power. Adjust
the amount of suction with the suction release on
the handle. Open the valve (a) by rotating the collar
90˚ counterclockwise for low suction when doing
light jobs such as drapes or fine surfaces. Close the
valve (a) by rotating the collar clockwise 90˚ for high
suction and when using the hand held accessories.
(Fig. 15)
4
Press the On/Off switch to the "I" position to turn the
vacuum on for above-floor cleaning.
IMPORTANT: Ensure vacuum is in upright position. Do
not use position "II" when cleaning above the floor in the
upright vac mode as this will engage the motorized floor
brush. The rotating brush may damage your floor if run for
a prolonged period of time in one area.
10 1-800-798-7398

With Floor Nozzle

Fig. 16
CLEAN THE FLOOR IN DETACHABLE CANISTER MODE
1 Press the extension wand release button and pull the
extension wand up.
2
Attach either floor nozzle onto the end of the extension
wand. (Fig. 16)
3
Press the On/Off switch to the "I" position to turn the
suction motor on.
NOTE: The rotating brush will not rotate in Detachable
Canister mode.
Storing
Quick
Cord
Release
Lower
Cord
Storage
Clip
Fig. 17
STORE YOUR VACUUM SAFELY
1
Convert your vacuum back to upright vac mode.
2
Rotate the upper quick cord release to its upright
position and coil the power cord loosely around the two
clips. Clip the plug onto the cord to secure. (Fig. 17)
3 Store the dusting brush and the crevice tool on the mounts
on the accessory holder.
4 Store your vacuum cleaner safely in a cool dry area where
it will not be a hazard, will not get damaged and will not
cause damage to anyone or anything.
NOTE: Empty dust cup after cleaning and prior to storing.
(See "Maintenance" section for instructions.)
Maintenance
To reduce the risk of electric shock, unplug the unit before
performing any cleaning, maintenance, or troubleshooting
checks.
Reassemble all parts securely before operating vacuum.
DO NOT operate the vacuum without the pre-motor filters
and dust cup in place.
DO NOT operate the vacuum with WET filters.
IMPORTANT: Make sure all filters are completely dry
before inserting back into vacuum.
IMPORTANT: Damages caused while clearing or
attempting to clear blockages are not covered under your
product's limited warranty.
Fig. 18 Fig. 19
sharkclean.com 11