Advertisement
Tabletop Maintenance
Maintaining the EzTilt Tabletop will allow many years of trouble
free cutting without replacement of the top. Maintenance is easy
and requires very little time compared to top replacement.
Some areas of the table will be used heavily and as a result will
break down much quicker than the rest of the table. The key is
to fill these areas before the structure of concrete slats are compromised and more extensive
resurfacing is needed.
When needed, at the end of the day, wash off the table and trowel into the cut groves on the
cement top with grey sanded thin set (mixed with 100% acrylic additive). The next morning,
quickly strike off any excess or high spots with a cinderblock or brick.
If the table is used heavily, filling the groves should be scheduled monthly. Under more moder-
ate usage you may only need to fill the table a few times a year.
Do not hesitate to cut into the table in an effort to reduce your maintenance on the table top.
Cutting 1/8" into the top is recommended and will properly dress the diamond blade, promoting
maximum production. On more abrasive stones, cutting into the table alone will be sufficient for
blade dressing. Hard non-abrasive granites will require supplemental dressing with a dressing
stone or cinder block. Refer to the AccuGlide directions for guidelines on proper diamond
blade dressing.
Please place the four steel shipping bases inside this crate along with the nuts, bolts, washers
and bottle jack. Secure the lid with the provided screws or hardware. We will contact you for a
ready time and schedule a shipping truck to pick up the crate at a designated address. If the
crate shipping bases are not ready for return after three attempts or not returned
by the customer within 30 days from the invoice date, the value of the bases and
crate will be billed at 500.00, to the original purchaser.
7
© 2010 Harris AccuGlide Saws, All Rights Reserved, Patents/Patents Pending
MAINTANENCE NOTE: The two center pivot bearings will
require limited maintenance for maximum performance. Using a
grease gun, insert grease into the four grease zerks every six
months. When performing this maintenance, continue inserting
grease until you see the old grease pushed out from each end of
the bearing. Wipe off excess grease with a rag.
RETURN SHIPPING BASES TO ACCUGLIDE SAWS
Fill cuts with Grey
sanded thin-set
Advertisement
