Accuglide EzTilt Instructions

Material List:

1. (10) 3 x 5' HardiBacker® Cement Board Sheets
2. (4) 3 x 5' Wonderboard Cement Board Sheets
3. (5) Silicone or latex caulking tubes
4. (1) 50lb Bag thin-set material with acrylic latex additive

Tool List:

Hammer Drill
•
1/4" Masonry Drill Bit
•
Jig saw
•
Bi-metal jig saw blade
•
Impact Screw Gun or Ratchet wrench
•
7/16" Socket
•
Grinder or saw
•
Diamond Blade
•

Material Cut List

A. (4 Pc.) 36 x 60" (full sheet)
B. (4 pc.) 35 x 60"
C. (1 pc) 15 3/4 x 35"
D. (1 pc) 15 3/4 x 36"
E. (1 pc) 16 1/2 x 35"
F. (1 pc) 16 1/2 x 36"
Installing HardiBacker® Board Layers
1) Preparing table for the Cement Board:
Install the cement board while the table is in
the vertical position. To prepare the table for
stacking, first clamp supports on the bottom of
the table (G. Orange Rectangles). Ensure the
supports are strong enough to handle the load of
the cement board. 4 x18" strips of wood, metal
or granite can be used . Clamp to the 3x3" table
beam with 4-8" C-Clamps.

2) Stacking the 1st layer:

Stack the 1st layer as depicted in figure 1. Refer
to the cut list above for specific dimensions on
each piece.
3) Calking the Joints:
Spread a bead of caulk were the 2nd layer will
overlap with the 1st layer of cement board. This
step will ensure correct water drainage. Work
quickly to step 4 before caulk sets up.
EzTilt Table DIY top Instructions
Caulking gun
•
2 1/4 hole saw bit
•
1/4" Notched trowel
•
(2) 5 gallon bucket
•
Paddle mixer for drill
•
Tile sponge
•
12 and 6' straight edge (or use your AccuGlide
•
Tracks)
Figure 1: 1st Layer
G.
B. E.
A.
F.
B.
A.