Advertisement
10
EzTilt Table Instructions and Guidelines
Use the Following Chart to Determine Correct Counter-Tension Cord Usage
WORKPIECE SIZE
Empty Table - No load
Large Countertop or Island
Small Slab
Large Slab
IMPORTANT NOTE ABOUT COUNTER-TENSION CORDS: Always store the EzTilt
Table in the vertical position. Whenever possible, at the end of the day, offload any stone
on the table and tilt the table back to the upright position. Leaving the table in the horizontal
position for more than a day will weaken the Counter-Tension Cords and limit their counter
balancing ability.
4
© 2010 Harris AccuGlide Saws, All Rights Reserved, Patents/Patents Pending
10) Check all four feet to ensured they're firm against the con-
crete slab. If any are high, spin the steel bolt down and
tighten the lock nut against the base
Congratulations! Assembly is now complete. Please read
and follow the directions below for proper table use.
1
BLUE
1) IMPORTANT SAFETY NOTE—Clip
Counter-Tension Cords in place before the ta-
ble is used under load.
The AccuGlide EzTilt Table is equipped with
four Counter-Tension Cords designed to bal-
ance the table while under load. CAUTION:
NEVER OPERATE THE TABLE WITHOUT THE
COUNTER-TENSION CORDS IN PLACE.
Always keep at least one Red Counter-Tension
Cord clipped in place when operating the table
dry or without load.
RED
BLUE
RED
Advertisement
