Advertisement
Completely remove all shipping crate materials from around the steel
shipping base before continuing to step 1.
CAUTION: Select a flat, hard area to assemble the table. Never assemble the table on a
soft surface such as dirt or gravel, or on any uneven or sloped surface.
A
1
1) Place supplied bottle jack under one side of table, approximately 6" from the inside corner
as pictured. Spin bottle jack head clockwise to lengthen the throw of the jack.
IMPORTANT NOTE: The bottle jack must be placed on a flat concrete slab. CAUTION:
Do not assemble the table on a soft surface such as gravel or an uneven hard surface.
2) Close the valve on the bottle jack clockwise with the provided handle.
3) Pump the jack handle, lifting the table no more than 1/8" off the ground.
4) Completely remove all six bolts connecting the base to the shipping leg with a 9/16" wrench.
2
© 2010 Harris AccuGlide Saws, All Rights Reserved, Patents/Patents Pending
B) IMPORTANT - Remove Shipping Bases and INSTALL
PERMANENT BASES ONE AT A TIME. CAUTION: Removing both
bases at the same time can cause the table to tip, resulting in
possible injury.
2
B
3
1/8"
4
Advertisement
