Advertisement
Two Replacement Counter-Tension Cords have been shipped with your EzTilt Package. We recom-
mend replacing the two center Cords eighteen months after the initial purchase. Under
normal use, replacement of the two center Counter-Tension Cords is recommended every eighteen
months following the first replacement or upon your maintenance evaluation if needed any sooner.
Replacement Cords can be purchased from AccuGlide Saws.
CAUTION: Regularly Inspect Counter-Tension Cords. If any defect from original condition is
found, immediately discontinue use of the table until replacement cords are acquired from AccuGlide.
2) After tilting the table to the horizontal position pull the lock pin and flip the Center Leg to the
down position.
3) Release the handle from the lanyard and crank the handle clockwise until
the table bottoms out on the leg posts (Fig. A).
CAUTION: DO NOT OVER CRANK HANDLE. Doing so will lift the table
off the ground, placing improper stresses on the frame and may cause
the table to rock.
CAUTION: NEVER WORK ON THE TABLE IN THE HORIZONTAL
POSITION WITHOUT THE CENTER LEG FLIPED DOWN AND SECURED.
Fig. B
20
Fig. C
5
© 2010 Harris AccuGlide Saws, All Rights Reserved, Patents/Patents Pending
2
4
KEEP CLEARANCE
4) IMPORTANT NOTE: When you're ready to tilt
the table back to the upright position, make
sure the leg is sufficiently retracted. Crank
the handle at least twenty times from the ex-
tended position.
CAUTION: If the leg is not retracted properly
it will hit the base and prevent the table from
reaching its full upright position. (Fig. C)
3
Fig. A
Advertisement
