Advertisement
Use Caution during steps 5-7. Never allow your hands or feet to be under any part of the
table during these steps
5) Check to ensure the shipping base is clear of the table leg. Carefully remove the base.
6) Carefully slide the permanent base into its approximate position.
7
1/16"
7) SLOWLY open the valve on the bottle jack and lower the table leg 1/16" above permanent base.
8) Start all six screws and lock washers to ensure proper alignment. Lower the leg the rest of the way
onto the table as pictured in step 7.
9) Tighten all six bolts with a 9/16" wrench. Ensure sufficient force is used but do not over tighten.
YOU'RE HALFWAY THERE! You're now ready to install the second base by repeating
steps 1-9. Once the second leg base is permanently installed continue to step 10.
3
© 2010 Harris AccuGlide Saws, All Rights Reserved, Patents/Patents Pending
5
8
6
9
Advertisement
