Page 1
SAVE THIS ASSEMBLY MANUAL FOR FUTURE REFERENCE IN THE EVENT THAT YOU NEED TO ORDER REPLACEMENT PARTS. Para obtener instrucciones en español, visite www.backyarddiscovery.com Made in China | INS-1803022-A-CANYON CREEK SWING SET-ENG 10-8-18...
Page 2
INSTALLATION SERVICES AVAILABLE! Need a helping hand? Let our team of professionals handle the installation for you! *Installation services are only available to U.S. customers. With Go Con gure, we bring you 18 years of experience right to your doorstep. We service a wide array of indoor and outdoor recreation products that most consumers don’t have the time or ability to deliver &...
Page 3
Owner’s Manual Please Read This Before Starting Assembly MISSING A PART? CALL US BEFORE GOING BACK TO THE STORE e store where you made your purchase does not stock parts for this item. If you have assembly questions or you are missing or have damaged parts, please call 1-800-856-4445 or visit www.backyarddiscovery.com...
Page 4
All wood carries a ve (5) year pro-rated warranty against rot and decay. Refer to the schedule below for charges associated with replacement of parts under this Limited Warranty. In addition, Backyard Discovery will replace any parts within the rst 30 days from date of purchase found to be missing from or damaged in the original packaging.
Page 5
Owner’s Manual Operating Instructions and Safety Warnings WARNING: BURN HAZARD • Pay special attention to plastic and metal surfaces as they may be hot enough to cause burns. • Always check the temperature of the product before NOTE: letting your children play on it. •...
Page 6
Owner’s Manual Please Read This Before Starting Assembly Positioning Your Playcenter Suggested Playground Surfacing • e playcenter is designed to be installed on a level • Do not install home playground equipment over surface by an adult with an adult helper. Place concrete, asphalt, packed earth, grass, carpet, or any in a at area of your yard to minimize ground other hard surface.
Page 7
Owner’s Manual Please Read This Before Starting Assembly APPENDIX A The following information is from the United States X3.1.3.2 Do not install loose- ll surfacing over hard surfaces such as concrete or asphalt. Consumer Product Safety Commission’s Information X3.1.4 Poured-In-Place Surfaces or Pre-Manufactured Sheet for playground surfacing material;...
Page 8
Check all moving parts including swing seats, third party person or service to assemble this product. ropes, cables, and chains for wear, rust, or other Backyard Discovery assumes no responsibility or deterioration. Replace as needed. liability for any charge incurred by the Customer for any assembly services’...
Page 9
About Our Wood Backyard Discovery uses 100% Cedar (C. Lanceolata) wood. Although we take great care in selecting the best quality lumber available, wood is still a product of nature and susceptible to weathering which can change the appearance of your set.
Page 10
Owner’s Manual Assembly Tips Protrusion Hazard Incorrect Correct If you see exposed threads and your bolt protrudes beyond the T-Nut you may have over tightened the bolt. To eliminate this, remove the bolt and add washers to eliminate the problem. 1/8”...
Page 11
Owner’s Manual Assembly Tips ASSEMBLY TIP: Keep an eye out for these boxes which will contain helpful pictures and information making the assembly process as quick and painless as possible. Sorting Wood When removing the wood from the boxes we recommend arranging them by part number before you begin assembly.
Page 12
Owner’s Manual Tools Required for Installation (These are the tools that are generally required for assembly of our outdoor products. These tools are not included with the outdoor product purchase.) (Level 24") (Square) (Open End Wrenches 1/2") (Phillips Screw Driver) (Tape Measure) (Claw Hammer) (Rubber Mallet - Optional)
Page 13
Basic Setup Dimensions Place the set on level ground, not less than 6 ft [2 m] from any structure or obstruction such as a fence, garage, house, overhanging branches, laundry lines, or electrical wires. 27'-7 5/8" General Information: Your set has been designed and engineered for children only and for residential use only.
Page 14
Parts Identification Wood Components (NOT TO SCALE) A74 - HEAVY DUTY SWING BEAM EXT.WEB SWING - W4L11647 3 3/8"x5 1/4"x89 1/2" (86x134x2274) (1) E1 - RIGHT REAR UPRIGHT - W2A02496 1 3/8"x3 3/8"x51 3/4" (36x86x1314) E2 - LEFT REAR UPRIGHT - W4L11117 1 3/8"x3 3/8"x51 3/4"...
Page 15
Parts Identification Wood Components (NOT TO SCALE) E72 - LEFT RAIL - W4L11168 1 3/8"x3 3/8"x54 7/8" (36x86x1395) E73 - RIGHT RAIL - W4L11169 1 3/8"x3 3/8"x54 7/8" (36x86x1395) E77 - ANGLE BRACE - W4L11648 1 3/8"x3 3/8"x73 1/8" (36x86x1859) E79 - END SUPPORT - W4L11650 1 1/2"x3 1/2"x42"...
Page 29
Parts Identification Accessories (NOT TO SCALE) SY - PLASTIC SUNBURST - A100322 HC - BYD ID TAG (LARGE) WITHOUT AGES - A100242 QU - SLIDE VF 10 FT - A100287 BY - SWING HANGER QUICK LINK - A4M00505-3 - GROUND STAKE REBAR - A4M00527 EZ - CHAIN GREEN 51.25"...
Page 30
Parts Identification Accessories (NOT TO SCALE) - "A" REVISION TAG - A100314 DQ - HAND GRIP GREEN PLASTIC - A100028 FA - QUICK LINK - A100069 - 90° L-BRACKET - BLK - A4M00555 LP - STEERING WHEEL - A100105 - L BRACKET 66x66x127 - BLK - A4M00619 - SWING BEAM EXTENSION BRACKET-LEFT - A4M00617 - SWING BEAM EXTENSION BRACKET-RIGHT - A4M00618 - L BRACKET BLACK 32x51 - A4M00710...
Page 31
Parts Identification Accessories (NOT TO SCALE) - GREEN HC ROCK #1 - A6P00036 - FAUCET KIT - A6P00024 - RED HC ROCK #1 - A6P00038 - SURFACE MOUNT BASIN - A6P00032 - BLUE HC ROCK #2 - A6P00040 - YELLOW HC ROCK #1 - A6P00042 LN - Telescope - A6P00096 (1) GRILL FOOD SET - 141154...
Page 32
Parts Identification Accessories (NOT TO SCALE) (1) GRILL - A6P00282 - CLIMBING ROPE - A6P00260 - 21" WEB SWING SEAT - A6P00285 - SWING SEAT GREEN 22IN - A6P00054...
Page 38
- BLUE HC ROCK #2 - A6P00040 - GREEN HC ROCK #1 - A6P00036 - YELLOW HC ROCK #1 - A6P00042 - RED HC ROCK #1 - A6P00038 ROCKWALL STEP 3 WASHER (24) LOCK INT BOLT PTH 8x15 (24) 1/4x3/4 (24) T-NUT 1/4 BOLT PTH 1/4x3/4...
Page 98
HC - BYD ID TAG (LARGE) WITHOUT AGES - A100242 STEP 56 ALIGN ID TAG IN THE CENTER OF SWING BEAM SCREW PWH 8x1/2 BLK BYD ID TAG (LARGE) WITHOUT AGES SCREW PWH 8x1/2 BLK (4 PLCS)
Page 99
EZ - CHAIN GREEN 51.25" - A100068 FA - QUICK LINK - A100069 - SWING SEAT GREEN 22IN - A6P00054 - 21" WEB SWING SEAT - A6P00285 STEP 57 TIGHTEN QUICK LINK INSERT CHAIN INTO QUICK LINK 21" WEB SWING SEAT CHAIN GREEN 51.25"...
Page 100
WEB SWING SETUP INSTRUCTIONS: FOLLOW INSTRUCTIONS BELOW BEFORE USING THE WEB SWING. IMPORTANT: SWING MUST BE SET AT A MINIMUM OF 8 INCHES OFF THE GROUND WHEN INSTALLED. IMPORTANT: TO ENSURE STRAIGHT SWINGING MOTION, ADJUST ALL (4) "S" BRACKETS UNTIL WEB SEAT IS LEVEL.
Page 101
- GROUND STAKE REBAR - A4M00527 STEP 58 Anchoring Instructions TAP IN GROUND STAKES AT AN APPROXIMATE 45° ANGLE AT THE WASHER BOLT WH LOCATIONS SHOWN. LOCK EXT 5/16x1/2 BLK 12x19 BLK USING GROUND STAKES AS A GUIDE, DRILL 7/16" DIA HOLES. NOTE: NUT BARREL NUT BARREL...
Need help?
Do you have a question about the Canyon Creek and is the answer not in the manual?
Questions and answers