Page 1
SAVE THIS ASSEMBLY MANUAL FOR FUTURE REFERENCE IN THE EVENT THAT YOU NEED TO ORDER REPLACEMENT PARTS. Para obtener instrucciones en español, visite www.backyarddiscovery.com Made in China | INS-1705012-A-MOUNT McKINLEY SWING SET 10-9-18...
Page 2
INSTALLATION SERVICES AVAILABLE! Need a helping hand? Let our team of professionals handle the installation for you! *Installation services are only available to U.S. customers. With Go Con gure, we bring you 18 years of experience right to your doorstep. We service a wide array of indoor and outdoor recreation products that most consumers don’t have the time or ability to deliver &...
Page 3
Owner’s Manual Please Read This Before Starting Assembly MISSING A PART? CALL US BEFORE GOING BACK TO THE STORE e store where you made your purchase does not stock parts for this item. If you have assembly questions or you are missing or have damaged parts, please call 1-800-856-4445 or visit www.backyarddiscovery.com...
All wood carries a ve (5) year pro-rated warranty against rot and decay. Refer to the schedule below for charges associated with replacement of parts under this Limited Warranty. In addition, Backyard Discovery will replace any parts within the rst 30 days from date of purchase found to be missing from or damaged in the original packaging.
Page 5
Owner’s Manual Operating Instructions and Safety Warnings WARNING: BURN HAZARD • Pay special attention to plastic and metal surfaces as they may be hot enough to cause burns. • Always check the temperature of the product before NOTE: letting your children play on it. •...
Page 6
Owner’s Manual Please Read This Before Starting Assembly Positioning Your Playcenter Suggested Playground Surfacing • e playcenter is designed to be installed on a level • Do not install home playground equipment over surface by an adult with an adult helper. Place concrete, asphalt, packed earth, grass, carpet, or any in a at area of your yard to minimize ground other hard surface.
Page 7
Owner’s Manual Please Read This Before Starting Assembly APPENDIX A The following information is from the United States X3.1.3.2 Do not install loose- ll surfacing over hard surfaces such as concrete or asphalt. Consumer Product Safety Commission’s Information X3.1.4 Poured-In-Place Surfaces or Pre-Manufactured Sheet for playground surfacing material;...
Check all moving parts including swing seats, third party person or service to assemble this product. ropes, cables, and chains for wear, rust, or other Backyard Discovery assumes no responsibility or deterioration. Replace as needed. liability for any charge incurred by the Customer for any assembly services’...
Page 9
About Our Wood Backyard Discovery uses 100% Cedar (C. Lanceolata) wood. Although we take great care in selecting the best quality lumber available, wood is still a product of nature and susceptible to weathering which can change the appearance of your set.
Owner’s Manual Assembly Tips Protrusion Hazard Incorrect Correct If you see exposed threads and your bolt protrudes beyond the T-Nut you may have over tightened the bolt. To eliminate this, remove the bolt and add washers to eliminate the problem. 1/8”...
Page 11
Owner’s Manual Assembly Tips ASSEMBLY TIP: Keep an eye out for these boxes which will contain helpful pictures and information making the assembly process as quick and painless as possible. Sorting Wood When removing the wood from the boxes we recommend arranging them by part number before you begin assembly.
Owner’s Manual Tools Required for Installation (These are the tools that are generally required for assembly of our outdoor products. These tools are not included with the outdoor product purchase.) (Level 24") (Square) (Phillips Screw Driver) (Open End Wrenches 1/2") (Tape Measure) (Claw Hammer) (Rubber Mallet - Optional)
Page 13
Basic Setup Dimensions Place the set on level ground, not less than 6 ft [2 m] from any structure or obstruction such as a fence, garage, house, overhanging branches, laundry lines, or electrical wires. General Information: Your set has been designed and engineered for children only and for residential use only.
Page 14
Parts Identification Wood Components (NOT TO SCALE) B1 - UPRIGHT POST - W2A02004 3"x3"x89 1/2" (76x76x2274) B2 - UPRIGHT POST - W4L07119 3"x3"x89 1/2" (76x76x2274) B3 - UPRIGHT POST - W4L07120 3"x3"x89 1/2" (76x76x2274) B4 - UPRIGHT POST - W4L07121 3"x3"x89 1/2"...
Page 21
Parts Identification Accessories (NOT TO SCALE) - ROPE LADDER - A6P00161 - CLIMBING ROPE - A6P00120 KN - CHAIN GREEN 31" - A100177 EZ - CHAIN GREEN 51.25" - A100068 EK - SLIDE RAIL 8' GREEN RIGHT - A100054 EL - SLIDE RAIL 8' GREEN LEFT - A100055 EM - SLIDE BED 8' YELLOW - A100056 - TARP - A6P00157...
Page 22
Parts Identification Accessories (NOT TO SCALE) - L-BRACKET 2.5x66x127 - A4M00695 GD - L BRACKET 66x66x127 - A100140 - GREEN HC ROCK #2 - A6P00037 TZ - L BRACKET 2.5x38x50x55 - A100340 TB - SWING BEAM EXTENSION BRACKET-LEFT - A100325 - RED HC ROCK #2 - A6P00039 FA - QUICK LINK - A100069 TC - SWING BEAM EXTENSION BRACKET-RIGHT - A100326...
Page 28
M77 - SLIDE BRACE - W100544 5/8"x3 3/8"x17 1/4" (16x86x438) EM - SLIDE BED 8' YELLOW - A100056 SLIDE ASSEMBLY STEP 1 T-NUT 5/16 BOLT WH 5/16x1/2 SLIDE BED 8' YELLOW (1 PLC) BOLT WH 5/16x1/2 (3 PLCS) T-NUT 5/16 (3 PLCS) USE 'M77' SLIDE BRACE AS A TEMPLATE AND USE A 3/8"...
Page 29
EL - SLIDE RAIL 8' GREEN LEFT - A100055 EK - SLIDE RAIL 8' GREEN RIGHT - A100054 M78 - CENTER SLIDE BRACE - W100545 5/8"x3 3/8"x17 1/4" (16x86x438) SLIDE ASSEMBLY STEP 2 SCREW PFH (24) 8x2 1/2 NOTE: MAKE CERTAIN SUPPORTS AND SLIDE BED ARE FULLY ENGAGED WITHIN...
Page 30
B1 - UPRIGHT POST - W2A02004 3"x3"x89 1/2" (76x76x2274) B4 - UPRIGHT POST - W4L07121 3"x3"x89 1/2" (76x76x2274) STEP 1 (16) T-NUT 5/16 NOTE HOLE LOCATION. T-NUT 5/16 LEFT (4 PLCS) T-NUT 5/16 (4 PLCS) FRONT RIGHT T-NUT 5/16 (4 PLCS) T-NUT 5/16 (4 PLCS)
Page 41
M2 - ROCK WALL BOARD - W4L07137 5/8"x3 3/8"x49" (16x86x1245) - GREEN HC ROCK #2 - A6P00037 - YELLOW HC ROCK #2 - A6P00043 M3 - ROCK WALL BOARD - W4L07138 5/8"x3 3/8"x49" (16x86x1245) - BLUE HC ROCK #1 - A6P00041 - RED HC ROCK #2 - A6P00039 STEP 12 ASSEMBLE T-NUTS INTO BOARDS BEFORE ROCK INSTALLATION.
FA - QUICK LINK - A100069 - SWING SEAT GREEN - A6P00054 EZ - CHAIN GREEN 51.25" - A100068 STEP 29 TIGHTEN QUICK LINK INSERT CHAIN INTO QUICK LINK CHAIN GREEN 51.25" (4 PLCS) QUICK LINK (4 PLCS) SWING SEAT GREEN (2 PLCS)
Page 59
KN - CHAIN GREEN 31" - A100177 FA - QUICK LINK - A100069 - TRAPEZE - A6P00034 STEP 30 TIGHTEN QUICK LINK INSERT CHAIN INTO QUICK LINK CHAIN GREEN 31" (2 PLCS) QUICK LINK (2 PLCS) TRAPEZE (1 PLC)
Page 60
HC - BYD ID TAG (LARGE) 2011 WITH AGES - A100164 STEP 31 BYD ID TAG (LARGE) 2011 WITH AGES (1 PLC) SCREW PWH 8x5/8 SCREW PWH 8x5/8 (4 PLCS)
Page 65
- CLIMBING ROPE - A6P00120 STEP 36 SLIP THE END OF THE ROPE THROUGH THE HOLE AND TIE A KNOT TO THE INSIDE OF FORT RAIL. TIE A KNOT APPROX. EVERY ". CLIMBING ROPE (1 PLC) SLIP THE END OF THE ROPE THROUGH THE HOLE AND TIE A KNOT TO THE INSIDE OF ROCK WALL BOARD.
Page 66
SQ - "A" REVISION TAG - A100314 STEP 37 SCREW PWH 8x5/8 (2 PLCS) SCREW PWH "A" REVISION TAG 8x5/8 (1 PLC)
- GROUND STAKE REBAR - A4M00527 Anchoring Instructions STEP 38 TAP IN GROUND STAKES AT AN APPROXIMATE 45° ANGLE AT THE LOCATIONS SHOWN. BOLT WH USING GROUND STAKES AS A GUIDE, DRILL 7/16" DIA HOLES. 5/16x1/2 NOTE: FAILURE TO USE GROUND STAKES CAN VOID WARRANTY & CAUSE INJURY! WASHER LOCK EXT NUT BARREL WH 5/16x7/8...
Need help?
Do you have a question about the 1705012 and is the answer not in the manual?
Questions and answers