JVC HR-V615EK Instructions Manual page 40

40 advanced features
programme satellite receiver
receiver (see receiver manual) and put a tape in the VCR.
set tape speed
engage vcr in auto mode
c indicator on the VCR display panel lights up and the VCR turns off automatically. Any
SAT
signal detected at the
when the signal stops, so will the VCR.
Notes
connectors
tor.
timer mode
Recording Mode.
r The number of programmes recorded will not be displayed on the VCR display
panel when the r button is pressed.
timer recording
not have a timer.
indicator
disengage
The VCR will stop recording and turns off.
tape speed
tape speed for each programme. The first speed selected will apply to all programmes in that
recording session.
The
b.e.s.t.
just clock Just Clock
incoming signal
connecter. If you try to engage Auto Satellite Prog Recording Mode whilst the satellite
DECODER
receiver is powered on, the
power the satellite receiver off then on again to begin recording in these circumstances.
cable input
cable system has a timer on/off function and is connected to the
incompatibilities
ers cannot be used with this VCR in this way.
HR-V615/616/617EK-EN/p29-42
Black
All manuals and user guides at all-guides.com
Enter the details of the programme into your satellite
Press / on the Remote Control to set the tape speed to either
Press and hold
connecter will automatically start the VCR recording;
L-2 IN/DECODER
Auto Satellite Prog Recording is only possible using the
You cannot put the VCR into
Auto Satellite Prog Recording is not possible if your satellite receiver does
The c indicator light flashes when Auto Satellite Prog Recording is in progress.
SAT
To disengage the VCR during Auto Satellite Prog Recording, press the o button.
When recording two or more programmes consecutively, you cannot set a different
system will not work during Auto Satellite Prog Recording.
B.E.S.T.
does not work when in Auto Satellite Prog Recording mode.
The VCR will only react to the start of an incoming signal at the
SAT c indicator light will flash but the VCR will not record. You must
You can record in the same way from a cable system as long as you connect the
Some satellite receivers output signals even when turned off. These receiv-
40
c (|)on the VCR for about 2 seconds. The
SAT
L-2 IN/DECODER
when using Auto Satellite Prog
TIMER MODE
L-2 IN/DECODER connector
3/8/04, 10:19 AM
SP or LP .
connec-
L-2 IN/
.