JVC HR-V615EK Instructions Manual page 19

HR-V615/616/617EK-EN/p13-20
Black
All manuals and user guides at all-guides.com
Notes on Recording
When using both the RF and SCART connections, you can switch between TV
and VCR by pressing the TV/VCR
If the tape reaches its end during recording, the recording stops and "U" and
"," on the display panel blink. Press S/0 on the VCR or
control to eject the tape or press < to rewind the tape.
Display Tape Remaining Time
Press the bbutton so that the tape remaining time is shown on the TV
screen with 'REMAIN' indication. The on-screen information will disappear
after about 5 seconds.
Sometimes, a tape will not conform to the standards
non-standard tapes
accepted by this VCR. In such cases the tape remaining time may not appear
immediately, be incorrect or simply show as '– – : – –'.
Change Display Information
By pressing the bbutton repeatedly, you can change the display on the VCR
between the clock time and the preset position. The preset position cannot be
shown during playback.
Resetting the Counter
Press the bbutton so that the counter display appears on the TV screen.
While the display is shown, press the
'0:00:00' before starting playback or recording.
Record a Programme While Watching Another
Once you have started recording all you need to do is use the controls on your
TV set to tune to a different programme. The programme set using
the Remote Control is the one which will be recorded.
19
basic features
button on the Remote Control.
0000 button. You can reset the counter to
3/12/04, 10:41 AM
19
on the remote
on
PR + / –