Installation - SmartRG SR570ac Quick Start Manual

INSTALLATION

Locate the splitter cable that is included with your SmartRG gateway. It has three ports.
1. Connect one end of an Ethernet cable to the wall jack installed by your service provider. Connect the
other end to the WAN port on the gateway.
2. Connect one end of an Ethernet cable to a LAN port on the gateway. Connect the other end to the
Ethernet port on your PC.
3. Plug the power adapter to the wall outlet and then connect the other end of it to the Power port of the
gateway.
4. Turn on the unit by pressing the Power button on the side of the gateway.
Your gateway is now automatically being set up to connect to the Internet. This process may take a few minutes to
complete before you can begin using your Internet applications (browser, email, etc.).
Notes:
If you use 3G WAN service, connect the 3G USB data card to the USB port of the gateway.
l
If you use DSL service, connect the supplied phone cable to a phone wall jack and the other end to the DSL port on
l
the gateway.
You cannot use the xDSL uplink, 3G WAN service, and Ethernet uplink at the same time.
l
If you are unable to connect to the Internet, confirm that all cable connections are in place and the gateway's
power is turned on.