Step 3 Insert Modules - Fujitsu SMARTCASE S500 Assembly Instructions Manual

Assembly Instructions SMARTCASE S500

Step 3 Insert Modules

In the following picture, you can see the board with the three appropriated M.2 WLAN Modules or storage:
M.2 2230
WLAN
M.2 2242
SSD/ Storage
M.2 SSD / Storage
2280
Next put the memory in tilted upwards and then push it down with a little pressure.
Attention: Do not touch the pin! Touch the memory at the outside edge. Do not stick a barcode on the memory!
The following procedure is necessary to make correct contact guarantee:

Insert memory at an angle and
pay attention to the notch!

Remove the memory again
completely from the DIMM slot!

Insert memory again

Press down on the memory until
it clicks into place

Do not press in the middle of the
memory, but press down on the
outer edges (yellow arrows on
the following picture)
__________________________________________________________________________________________________________________________________________________________
Page 6 of 23
Mainboard
Memory
www.fujitsu.com