FujiFilm X-H1 Owner's Manual page 135

This product complies with the following EU Directives:
•
RoHS Directive 2011/65/EU
•
RE Directive 2014/53/EU
Hereby, FUJIFILM Corporation declares that the radio
equipment type FF170002 is in compliance with Directive
2014/53/EU.
The full text of the EU declaration of conformity is available
at the following internet address: http://www.fujifilm.com/
products/digital_cameras/x/fujifilm_x_h1/pdf/index/
fujifilm_x_h1_cod.pdf
This compliance is indicated by the following conformity
marking placed on the product:
This marking is valid for non-Telecom products and EU harmo-
nized Telecom products (e.g. Bluetooth®).
IMPORTANT: Read the following notices before using the cam-
era' s built-in wireless transmitter.
Q This product, which contains encryption function de-
veloped in the United States, is controlled by the United
States Export Administration Regulations and may not
be exported or re-exported to any country to which the
United States embargoes goods.
•
Use only a wireless network or Bluetooth device. . FUJIFILM Use only a wireless network or Bluetooth device
does not accept liability for damages resulting from unau-
thorized use. Do not use in applications requiring a high
degree of reliability, for example in medical devices or other
systems that may directly or indirectly impact human life.
When using the device in computer and other systems that
demand a greater degree of reliability than off ered by wire-
less network or Bluetooth devices, be sure to take all neces-
sary precautions to ensure safety and prevent malfunction.
•
Use only in the country in which the device was purchased. This Use only in the country in which the device was purchased.
device conforms to regulations governing wireless network
and Bluetooth devices in the country in which it was pur-
chased. Observe all location regulations when using the
device. FUJIFILM does not accept liability for problems
arising from use in other jurisdictions.
•
Do not use the device in locations subject to magnetic fi elds, Do not use the device in locations subject to magnetic fi elds,
static electricity, or radio interference. Do not use the trans- static electricity, or radio interference.
mitter in the vicinity of microwave ovens or in other loca-
tions subject to magnetic fi elds, static electricity, or radio
interference that may prevent reception of wireless signals.
Mutual interference may occur when the transmitter is
used in the vicinity of other wireless devices operating in
the 2.4 GHz band.
•
The wireless transmitter operates in the 2.4 GHz band using The wireless transmitter operates in the 2.4 GHz band using
DSSS, OFDM and GFSK modulation. DSSS, OFDM and GFSK modulation.
Wireless Network and Bluetooth Devices: Cautions
•
Security: Wireless network and Bluetooth devices transmit
data via radio and consequently their use requires great-
er attention to security than applies in the case of wired
networks.
-
-
•
The following may be punishable by law: The following may be punishable by law:
-
-
•
This device operates on the same frequency as commercial, edu- This device operates on the same frequency as commercial, edu-
cational, and medical devices and wireless transmitters. It also
cational, and medical devices and wireless transmitters.
operates on the same frequency as licensed transmitters
and special unlicensed low-voltage transmitters used in
RFID tracking systems for assembly lines and in other sim-
ilar applications.
•
To prevent interference with the above devices, observe the fol- To prevent interference with the above devices, observe the fol-
lowing precautions. lowing precautions. Confi rm that the RFID transmitter is not
in operation before using this device. Should you observe
that the device causes interference in licensed transmitters
used for RFID tracking, immediately stop using the aff ected
frequency or move the device to another location. If you
notice that this device causes interference in low-voltage
RFID tracing systems, contact a FUJIFILM representative.
•
Do not use this device on board an aircraft. Note that Bluetooth
Do not use this device on board an aircraft.
may remain on even when the camera is off . Bluetooth
can be disabled by selecting OFF for
SETTING > Bluetooth SETTINGS > Bluetooth ON/
OFF.
Do not connect to unknown networks or networks to
which you do not have access rights, even if they are
displayed on your device, as such access may be consid-
ered unauthorized. Connect only to networks to which
you have access rights.
Be aware that wireless transmissions may be vulnerable
to interception by third parties.
Disassembly or modifi cation or this device
Removal of device certifi cation labels
For Your Safety
D
CONNECTION
12
267