Installing Hardware And Drivers; Installing The Multiport Module And Drivers - Compaq 802.11b MultiPort Installation Manual

Installing Hardware and Drivers

✎
Before installing the 802.11b MultiPort Module on a new
computer, the computer software setup process should be
completed and the operating system should be fully operational.
Refer to the "Setting Up the Software" section in the Getting
Started guide included with the computer.
✎
If you have previously installed a wireless LAN device, such as a
PC Card, you must uninstall the wireless LAN drivers and
software according to the device manufacturer's instructions.
Before installing the 802.11b MultiPort Module hardware, insert
the software CD, included with the MultiPort Module accessory
kit, into the CD drive. When the computer is turned on after
installing the hardware, this ensures that the operating system will
prompt you for drivers after detecting the new hardware.

Installing the MultiPort Module and Drivers

To install the MultiPort Module and essential drivers:
1. Insert the MultiPort Module software CD into the CD drive.
2. Turn off the computer.
3. Disconnect any external devices.
4. Remove all battery packs.
Installation Guide
2
2–1