Final Product Requirements; Frequency Bands; Antenna Use And Transmit Power; Certified Antennas - Redline RDL-3000 Series Product Manual

RDL-3000 RMG3 MODULE
4

Final Product Requirements

The following requirements apply to all final products incorporating an RDL-3000-RMG3,
module.

4.1 Frequency Bands

Operation of the final product requires a software 'key' that is available exclusively from
Redline. This key restricts device operation to the FCC/IC 4940-4990 MHz and 5725-
5850 MHz or FCC 5150-5250 MHz MHz band. The professional installer and operator
can not modify or otherwise circumvent these operational restrictions.

4.1.1 Antenna Use and Transmit Power

The module supports operation with 2x2 MIMO antenna systems with two transmit
chains and two receive chains. The module must be used only with certified antennas
and using the channel size and output power level specified by the FCC/IC regulations.

4.1.2 Certified Antennas

This device has been designed to operate with the antennas listed in the following table.
Any additional antennas will be used only after authorization is obtained through Class II
permissive change.
Manufacturer
L-Com
Redline *
Redline
Redline
Redline
* Alternate (equivalent) antenna.
70-00184-10-01

Table 1: Approved Antennas

Part #
HG5158DP-10U
AOD-DB-0512-02
30-00328-50
30-00362-00
A3FT3204LTPD
Proprietary Redline Communications © 2017
PRODUCT MANUAL
Gain
Frequency Range
(dBi)
10 5100-5800 MHz
10 4940-5875 MHz
19 4900-5875 MHz
24 4900-6100 MHz
32 4900-5875 MHz
Page
4940- 5150- 5725-
4990 5250 5850
MHz MHz MHz
PMP PMP PMP
PMP PMP PMP
PTP PTP
PMP
PMP PMP
PTP PMP
PMP
PMP PTP
PTP PTP
PMP
PMP PMP
10 of 26 September 21, 2017