Page 2
INSTALLATION INSTRUCTIONS VOLT Forged Brass Underwater Light ® VUL-680 Series Important: Please Read Before Installation This luminaire is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.
IMPORTANT SAFETY INSTRUCTIONS INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS Lighted lamp is HOT! WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS. 1. Turn off/unplug and allow to cool before replacing lamp. 2.
Page 4
INSTALLATION INSTRUCTIONS VOLT Forged Brass Underwater Light ® VUL-680 Series Remove Lens Assembly Lock Screw Using a screwdriver, loosen the lock screws and remove the lens assembly from the fixture body. Lens Assembly Fixture Body Install Lamp Insert the lamp with the correct...
Page 5
Install Lens Assembly Lock Screw Place the lens assembly back onto the fixture body and secure with lock Lens Assembly screws. Tighten until snug with a screwdriver. Fixture Body Mount Fixture Body Postion the fixture body in a desired location. Using the slots on the fixture Washer (not base, mark the two mounting points.
Page 6
INSTALLATION INSTRUCTIONS VOLT Forged Brass Underwater Light ® VUL-680 Series Wire Connection Fixture Transformer (sold separately) Pigtail Supply Cable Lay out the supply cable to the transformer. Strip both of the leads from the luminaire pigtail. Connect the leads from the luminaire supply cable to the transformer (sold separately).
Need help?
Do you have a question about the VUL-680 Series and is the answer not in the manual?
Questions and answers