Page 2
INSTALLATION INSTRUCTIONS VOLT Stratum 9” & 12” Path & Area Light ® VPL-300 Series Important: Please Read Before Installation This luminaire is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.
Package Contents A. (1) Finial E. (1) Harp B. (1) Waterproof Washer F. (1) Stake C. (1) Shade G. (1) Rod with Socket D. (1) Inner Shield Product Dimensions Install Stake Determine the desired location for mounting Board the luminaire. Hammer the stake into the ground until flange of stake is flush to grade.
Page 4
INSTALLATION INSTRUCTIONS VOLT Stratum 9” & 12” Path & Area Light ® VPL-300 Series Remove Harp and Glass Lens Screw the harp off the socket assembly. Harp Remove the harp and glass lens from the socket assembly. Glass Lens Socket...
Page 5
Install Shade Finial Place the shade and waterproof Waterproof washer on the top end of the harp Washer and secure with the finial. Hand tighten until snug. Shade Harp Install Luminaire to Stake Clear away an area in the ground at the wireway slot in the top of the stake.
Page 6
INSTALLATION INSTRUCTIONS VOLT Stratum 9” & 12” Path & Area Light ® VPL-300 Series Wire Connections Pigtail Wire Connectors Main Low Voltage Supply Cable Strip both of the leads from the luminaire pigtail. Using two wire connectors (sold separately), connect the leads from the luminaire to the main low voltage supply cable leads.
Need help?
Do you have a question about the Stratum 9 inch and is the answer not in the manual?
Questions and answers