Gardena EasyCut Li-18/23 R Operating Instructions Manual page 10

s
B
Problem
The Trimmer is not cutting
cleanly or not cutting at all
The trimmer vibrates severely
The trimmer does not start
The trimmer stops.
ß
Error­LED flashes
W
Charging control lamp
the charger does not illuminate
Charging control lamp
the charger flashes red
The trimmer stops.
ß
Error­LED flashes
W
The battery can no longer
be charged
Only an original GARDENA BLi-18 Replaceable Battery (Art. 9839) may be used.
This can be obtained from your GARDENA dealer or directly from GARDENA Service.
22
Disassembling the plastic blade:
1. Turn the trimmer over.
2. Press end of blade down slightly (A), slide blade
A
through blade carrier
Assembling the plastic blade:
v Slide new blade
s
carrier
When the new blade is correctly inserted, it can be moved more
easily.
e
Possible Cause
Blade worn or too short.
Blade broken off.
The blade is excessively worn
and creates an unbalance.
Battery is flat.
Battery not pushed onto the
handle properly.
Motor blockage.
Battery overload.
High temperature. The allowed
operation temperature was
exceded.
9
on Battery charger or charging
cable not plugged in properly.
9
on Charging error.
Battery error /
battery defective.
Battery is defective.
s
(B) and pull out.
e
from inside through slot in metal of blade
until it snaps into place.
Remedy
v Replace blade.
v Replace blade.
v Replace blade.
v Charge battery
v Push battery onto the handle
v Unblock and restart the
v Wait for 10 sec.
v Leave battery to cool for
v Plug in battery charger and
v Unplug charger and plug
v Press button
v Replace the battery
e
inside
(see 3. Initial Operation).
and make sure that the locking
buttons snap in correctly.
device.
ß
Press button on the battery
B
and restart.
approx. 15 min. Press
ß
button on the battery
B
and restart.
charging cable properly.
in again.
ß
on the
B
battery and restart.
(Art. No. 9839).