Craftsman 124.58833 Operator's Manual page 8

ATTACH RIP FENCE STORAGE BRACKETS
Refer to Figure 11.
Tools Required: 4mm Hex wrench and 10mm Open end
wrench.
Hardware Required: Two M6 x 16 socket pan head screws,
two 6mm flat washers and two 6mm hex nuts (Hardware bag
#4).
• Place rip fence bracket into position against right side panel
of cabinet.
• Insert washer onto bolt. Insert bolt through hole and thread
nut onto bolt end on inside of panel.
• Repeat for other bracket.
Figure 11
Rip Fence Storage
Bracket (x2)
BLADE GUARD, PUSH STICK
STORAGE BRACKETS, RUBBER FEET
Refer to Figure 12-1.
Tools Required: Phillips screwdriver.
Hardware Required: Eight M4 x 8 pan head screws, eight
4mm flat washers (Hardware bag #4).
• Install the push stick storage brackets to the left side panel
of the base using four M3 x 10 screws, four M3 lock
washers and four M3 flat washers.
• Install the blade guard storage brackets to the left side
panel of the base using four M3 x 10 screws, four M3 lock
washers and four M3 flat washers.
NOTE: Attach the slotted bracket to the front side of the saw.
Figure 12-1
Rubber Feet
Blade Guard
Storage
Brackets
Push Stick
Storage
Bracket (x2)
• Press the four molded plastic feet onto the base legs.
• With the aid of an assistant turn the saw upright. First, turn
the saw onto the back side. Then raise saw upright onto the
base feet.
WARNING: To avoid injury, Do Not attempt to turn saw
upright by yourself.
TEST CASTER MECHANISM
Refer to Figure 12-2.
Press down on the foot pedal to raise the saw up onto the
casters. Move the saw back and forth on the casters to
ensure that the mechanism is properly working. Press the
foot pedal again to lower the saw onto the floor into a
stationary position.
Figure 12-2
Foot Pedal
ATTACH EXTENSION TABLES
Refer to Figure 13.
IMPORTANT: Table is coated with a protectant. To ensure
proper fit and operation, remove coating. Coating is easily
removed with mild solvents, such as mineral spirits, and a
soft cloth. Avoid getting solution on paint or any of the rubber
or plastic parts. Solvents may deteriorate these finishes. Use
soap and water on paint, plastic or rubber components. After
cleaning, cover all exposed surfaces with a light coating of
oil. Paste wax is recommended for table top.
WARNING: Never use highly volatile solvents. Non flamma-
ble solvents are recommended to avoid possible fire hazard.
Tools Required: 8mm Hex Wrench and Straight Edge (not
included).
.
Hardware Required: Six M10 x 25 socket head bolts, six
10mm lock washers and six 10mm flat washers (Hardware
bag #1).
• Assemble extension table to the table using socket head
bolts, lock washers and flat washers.
• Wipe surface clean.
• Hand tighten only. Do not tighten completely until tables
are level. Use a straightedge to level tables.
• Repeat above procedure for the other extension table.
• Use a straight edge to check level and flatness between
main and extension tables between main and extension
tables along their entire length.
• After tables are adjusted level and flat, secure the exten-
sion tables by tightening the bolts completely.
8