Craftsman 124.58833 Operator's Manual page 7

• Loosen and remove the pre-installed bolts and hex nuts
from the brackets (see Figure 7).
• Rotate foot pedal bar so that foot pedal is pointing down
towards the floor.
• Place casters onto the brackets and secure in position with
bolts and hex nuts provided.
Figure 7
Hex Nut
Foot Pedal
ATTACH CASTER SETS TO BASE
Refer to Figure 8.
Tools Required: Hex wrench 5mm, Hex wrench 6mm and
13mm Open end wrench.
Hardware Required: Eight M8 x 16 socket pan head screws
(Hardware bag #4).
• Attach the foot pedal caster set to the two front corner
supports using four M8 x 16 socket pan head screws.
• Attach the link block caster set to the two rear corner
supports.
• Remove the socket head bolt and hex nut from the foot
pedal, insert the link plate into the slot of foot pedal and
secure in place with the socket bolt and hex nut.
• Remove the socket head bolt and hex nut from the link
block of rear caster set, insert the link plate into the slot of
link block and secure in place with the socket bolt and hex
nut.
Figure 8
M8 x 16 Socket
Pan Head Screws
(8)
Foot Pedal
Panel A (front)
Bolt
Link Block
Link Plate
7
ATTACH CORD WRAP HOOKS
Refer to Figure 9.
Tools Required: Hex wrench 4mm and 10mm open end
wrench.
Hardware Required: Two M6 x 20 socket pan head screws,
two M6 flat washers and two M6 hex nuts (Hardware bag
#4).
• Place cord wrap hook into position on motor housing.
• Insert washer onto bolt. Insert bolt through hole and thread
nut onto bolt end on inside of housing.
• Repeat for other hook.
Figure 9
Flat Washer
M6
Hex Nut
Cord Wrap
Hook
M6 x16 Socket
Pan Head
Screw
ATTACH BASE TO CABINET
Refer to Figure 10.
Tools Required: 8mm Hex Wrench.
Hardware Required: Four M10 x 25 socket head bolts, four
M10 lock washers and four M10 flat washers (Hardware bag
#4).
• Place dust chute over the cabinet as shown. Make sure
the holes in the corners are aligned with the slots in the
dust chute.
• Place the base assembly over the dust chute and secure
the base assembly to the cabinet using the flat washers,
lock washers and bolts.
• Secure all fasteners in the base assembly fully tight.
Figure 10
Dust Chute
M6
Bolt/Lock Washer/Flat
Washer (x4)