Craftsman 124.58833 Operator's Manual page 10

Figure 18
Trunnion Bolts (x4)
• Tighten the four trunnion hex head bolts and lock washers
securely.
This procedure will set the table and blade in parallel
position and prevent the trunnion from shifting.
NOTE: If you perform this adjustment, leave the back panel
off to perform rear rail assembly as described in the next
section.
RAIL ASSEMBLY
Refer to Figures on Pages 10 and 11.
Tools Required: 13mm Open end Wrench
Hardware Required: Sixteen M8 x 30 hex head bolts,
sixteen 8mm lock washers, sixteen 8mm flat washers and
sixteen M8 hex nuts. (Hardware bag #2).
Figure 19
M8 Flat & Lock
Washers
M8 x 30 Hex
Head Bolts
Short Rail
(Left)
Long Rail
RAIL ASSEMBLY Cont.
Refer to Figures on Pages 10 and 11.
NOTE: For this procedure the longer rail is installed to the
right; the shorter rail is installed to the left.
• Assemble the left front rail to the right front rail. Slide the
protruding pins from the left rail into the pin slots of the right
rail.
• Insert four M8 x 30 hex head bolts into the T-slot of the right
front guide rail.
• Insert four M8 x 30 hex head bolts into the T-slot of the left
front guide rail.
• Attach the assembled front rail to the table casting and to
the right and left table extensions using flat washers, lock
washers and hex nuts.
M8 Hex
Head Nut
(Right)
NOTE: Hand tighten all hardware during rail assembly. Do
not completely tighten hardware until all rails are mounted.
NOTE: You may have to shift right rail as far right as it will go
to attach left rail.
• Position rails so that rails are butted together and the joint
between rails is aligned with right side of the blade. You
may need a mallet to lightly tap rails together. Make sure
rails are completely butted together at the joint.
Figure 20
• Use a straight edge to align right edge of rail joint to blade.
Fully tighten right rail.
• Use a level to check level and flatness between right and
left rail. When level, fully tighten left rail.
• Before proceeding, ensure all hardware is tightly secured.
Figure 21
• To allow for attachment of rear rails, loosen and remove the
six socket pan head screws and back panel. Figure 23,
page 11.
• Install and level the rear rails in the same manner as the
front rails. Use a straight edge to align the left edge of rail
joint to the blade. Figure 22, page 11.
• Before proceeding, ensure all hardware is tightly secured.
• Replace back panel of the cabinet. Figure 23, page 11.
10
Straight Edge
Rail
Joint
Check Gap
Along Rail