Maintenance By The Installer - Breeze VT3130 Installation And Operation Manual

Hot water heat pump
Table of Contents

Advertisement

Available languages

Available languages

MAINTENANCE BY THE INSTALLER:

• General check:
The installer has to check on smooth operating and the state of the installation (safety group, leakages, excess pressure etc.).
• Maintenance of the anode
The state of the anode is either checked automatically (signal anode) or has to be checked manually at least once a year. The
checking interval is dependent on the local water composition. In extreme cases it might be necessary to check the anode
more often. Your installer should be perfectly aware of the local conditions to advise the best interval. To inspect the anode,
the front door must be removed. The anode is situated in the middle of the tank behind the front plate. It must be replaced
when the diameter is < 10 mm. The absolute minimum limit for the anode diameter is 6 mm. With < 6 mm anode diameter
the additional catholic protection will not work (no manufacturer's warranty).
• Maintenance of the evaporator
Examine the evaporator, and if necessary remove dust and dirt, once or twice a year. To inspect the evaporator, remove the
air grating/duct connections. Dust particles can obstruct the air circulation, and this will reduce the HP performance
considerably. Clean the evaporator with water and a brush. Be careful and avoid damaging the fins of the evaporator and
keep the water away from the electrical parts
• Maintenance of the drain
The discharge pipe of the heat pump must be connected to a drain in accordance with the present regulations. The
defrost/condensed water outlet of the heat pump must always be kept free from dirt. How often this has to be done, depends
on the local conditions concerning dirt and temperature.
The user is responsible for checking and cleaning the drain water outlet/hose. This issue has also to be checked by the
installer during the maintenance service.
NOTE: A defective drain might cause multiple damages, such as defect electronic part, external corrosion, rotten insulation.
The manufacturer's warrantee does not cover these damages.
Reprezentant unic in Romania - airguru.ro
BREEZE HVAC SRL
22

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vt3131Vt3132

Table of Contents