Honeywell SiX Series Installation Instructions Manual page 6

REPLACING THE BATTERIES
Remove old batteries. Wait 10 seconds and then
replace with two new batteries. To avoid a low battery
indication when installing new batteries, both batteries
must be installed within 15 seconds of installing the
first one. Any low battery condition that may have
occurred should clear when the base plate is installed.
CAUTION!
The batteries used in this device may present a fire or
chemical burn hazard if mistreated. Do not recharge,
disassemble, heat above 100°C (212°F) or dispose
of in fire. Use only Panasonic CR123A OR
DURACELL DL123, DL123A Lithium batteries. Use
of other batteries may present a risk of fire or
explosion. Keep used batteries away from children.
Dispose of used batteries properly.
BATTERY REPLACEMENT /
CLEANING
NOTE: Notify the proper authorities when the system
will be temporarily out of service.
IMPORTANT:
This detector must be tested and maintained regularly
following NFPA-72 requirements. The detector
should be cleaned at least once a year.
Remove the detector from the base plate by
1.
turning counterclockwise.
Clean the outside casing with a cloth. Ensure that
2.
the holes on the front of the detector are not
blocked with dirt and dust. Canned air can be used
to remove any dust or debris.
Reattach the detector to the base plate by rotating
3.
clockwise.
Test the detector to insure it is fully functional.
4.
(See Testing section).
Notify the proper authorities and Central Station
when the system is back in service.
BATTERY REPLACEMENT
6
REPLACING THE BATTERIES
Remove old batteries. Wait 10 seconds and then replace
with two new batteries. To avoid a low battery indication
when installing new batteries, both batteries must be
installed within 15 seconds of installing the first one. Any
low battery condition that may have occurred should
clear when the base plate is installed.
CAUTION!
The batteries used in this device may present a fire
or chemical burn hazard if mistreated. Do not
recharge, disassemble, heat above 100°C (212°F)
or dispose of in fire. Use only Panasonic CR123A
OR DURACELL DL123, DL123A Lithium batteries.
Use of other batteries may present a risk of fire or
explosion. Keep used batteries away from children.
Dispose of used batteries properly.
CLEANING
NOTE: Notify the proper authorities when the
system will be temporarily out of service.
IMPORTANT:
This detector must be tested and maintained regularly
following NFPA-72 requirements. The detector should
be cleaned at least once a year.
Remove the detector from the base plate by turning
1.
counterclockwise.
Clean the outside casing with a cloth. Ensure that
the holes on the front of the detector are not blocked
with dirt and dust. Canned air can be used to remove
any dust or debris.
Reattach the detector to the base plate by rotating
2.
clockwise.
Test the detector to insure it is fully functional. (See
3.
Testing section).
Notify the proper authorities and Central Station
when the system is back in service.