Montage - Honeywell SiX Series Installation Instructions Manual

MOUNTING
After enrolling and before mounting permanently,
conduct Go/No Go test (see controller's instructions) to
verify adequate signal strength. Adjust the device
location as necessary.
1. Remove the CO with a counter-clockwise motion.
2. Using two supplied screws and anchors, mount the
base.
3. Attach the CO detector to the mounting base with a
clockwise motion.
4. Test each detector as described in the Testing section.
5. Confirm all desired signals have been received by the
Central Station.
NOTE:
NFPA 72 recommends the installation of detectors only
after completing construction or any other dust
producing activity.
Ceiling Mount / Ceiling Mount

MONTAGE

After enrolling and before mounting permanently,
conduct Go/No Go test (see controller's instructions) to
verify adequate signal strength. Adjust the device
location as necessary.
1. Remove the CO with a counter-clockwise motion.
2. Using two supplied screws and anchors, mount the
base.
3. Attach the CO detector to the mounting base with a
clockwise motion.
4. Test each detector as described in the Testing section.
5. Confirm all desired signals have been received by the
Central Station.
NOTE:
NFPA 72 recommends the installation of detectors only
after completing construction or any other dust
producing activity.
Wall Mount / Wall Mount
3