Siemens SIMATIC IPC277E 19" INOX PRO Operating Instructions Manual page 12

Installing the device
3.2 Mounting and connecting the device
Opening the connection compartment and installing the device
Note
The device is fastened to a stand or a support arm via the mechanical interface with four
screws.
Siemens AG assumes no liability for the consequences of a faulty installation.
The device must be mounted securely
Inadequately dimensioned fastening material may cause the device to fall down. Serious
bodily injury may result.
Make sure that fasteners are adequately dimensioned during installation of the device.
Make sure to consider the weight of the device and the forces acting on the device when
dimensioning the fasteners. This applies in particular to dynamic load of the device.
Observe any further statutory specifications applying at the location of use of the device
and further applicable regulations with regard to the fastening of the device.
NOTICE
Placing the device on its front side
Place the device on a soft and elevated surface during installation so that the front is not
scratched.
12
WARNING
Compact Operating Instructions, 05/2017, A5E37416443-AE
IPC277E 19" INOX PRO