Installing The Rear Rail; Installing The Long And Short Rail - MacMah MJ2325A Owner's Manual

5. Put the left end cap on the rail end, insert the tapping
screw and tighten with phillips screwdriver.

8.4 Installing the rear rail

Warning:
The front and rear rails must be carefully aligned to
reduce the risk of kickback,which can cause serious
injury.
Take out the rear rail from carton.
Locate the following hardware from a hardware bag in
the major case:
4-square head bolt M8×25
4-8mm flat washer
4-M8 hex nuts.
1. At the back of the table put the square head bolts in
the holes in the edge of the table and extension so the
bolt heads extend outward 6mm.
2. Loosely attach the flat washer and hex nut onto
bolts,slide the solt on the rear rail over bolts,adjust
each bolt to fit the rail closely to the table.
3. Push the rear rail against table and tighten all screws.
Note:
Make sure there are no gaps between the rail and edge of
table or extension.

8.5 Installing the long and short rail

Take out the plastic bag from the major case,in this bag you can
find the following parts will be used for installing the long and
short rails.
2-supporting and connection plate of rail(F52)
4-flat washer 8(F04)
4-hex head screw M8×18(F60)
1-brace accessory(F53,54,55,56)
2-adjustable link pole(F02)
2-short guide axle(F06)
2-long guide axle(F07)
4-hex socket cap head screw M8×35(F08)
4-spring washer 12(F73)
4-flat washer 12(F74)
4-hexagon nut M12(F75)
Locate long rail and short rail from the accessory case.
Warning:
The long rail and short rail must be carefully aligned to