Installing The Lateral Fence; Installing The Rip Fence - MacMah MJ2325A Owner's Manual

the same level position, loosen the two hex socket cap
18( )
head screws M8× F09
M8×40(
F58) to have the two supporting blocks remove,
and this can have the sliding table's left side up and down,
after adjustment, lock all the screws by wrench..

8.8 Installing the lateral fence

Take out the lateral fence from the only carton
Warning:
The lateral fence must be carefully aligned to reduce
the risk of kickback, which can cause serious injury.
1. Before installing this part, make sure the distance
between the right edge of protection board(F36) and
lateral fence(F23) is 29mm ,if not , loosen the two
cross recessed countersunk head screw M8×
the bottom of protection board and remove
protection board to the proper position , tighten the
two screws.
10
2. Loosen 2-M8× slotted set screws(F33)in the
bottom of lateral fence slightly, place the lateral fence
on the sliding table and insert the core axle for lateral
fence(F32) in the right hole close to
pole(F31), adjust the distance from the right edge of
lateral fence to the left edge of saw blade by remove
the lateral fence , the exact distance should be 30mm,
this can guarantee the workpiece's width being
cutted agree with the scale (F28) on the lateral fence.
slightly, adjust the two bolts
18
in
vertical

8.9 Installing the rip fence

1. Unpacking the rip fence part from fence carton.
2. Place the rip fence assembly on the scale mount.
3. If need, attach the "L" shape extension to the rip
fence.
4. Slide the rip fence onto the rear and front rails.
Caution
This fence has a set micro adjusting device,
which be positioned on the right side of the
scale indicator housing when you sure the
exact position by adjusting the rip fence and
micro device, you should push down the rip
fence handle to lock the rip fence.