Care And Maintenance; Saw Blade Change - MacMah MJ2325A Owner's Manual

Care and maintenance

10.
Danger!
Prior to all servicing:
–Switch machine OFF.
–Unplug power cable.
–Wait until the saw has come to a
complete stop.
·Check that all safety devices are operational
against after each service.
·Replace defective parts, especially of safety
devices,only with genuine replacement parts.
Parts not tested and approved by the
equipment maker can cause unforeseen
damage.
·Repair and maintenance work other than
described in this section shall be only carried
out by qualified specialists.

10.1 Saw blade change

Danger!
Risk of injury by the saw blade's teeth.Wear gloves
when changing blades.
1. Remove blade guard.
2. Lower saw blade fully.
3. Loose 6 screws on cover plates. Remove
throat plates slightly.
4. Raise saw blade fully.
5. To block the saw blade insert lock bar into
hole in the saw table and turn saw blade
by hand until lock bar engages in saw spindle
hole.
6. Loose saw blade spindle arbor nut with spanner
(L.H.thread!)
7. Take outer blade collar and saw blade off the saw
spindle.
8. Clean clamping surfaces of saw spindle and saw
blade.
Danger!
Do not use cleaning agents (e.g.for removing
resin residue) that could corrode the light metal
components the saw, the stability of the saw
would be adversely affected.
9. Put on a fresh saw blade.
Danger!
Use only suitable saw blades-when using unsuitable
damaged blades parts could be explosive like hurled
from it by the centrifugal force.
Do not use:
–saw blades with visible damage;
–cut-off wheel blades.
10. Slide outer blade collar onto saw spindle.
11. Screw arbor nut, with the low side facing the blade,
onto the saw spindle (L.H.thread)