Cleaning The Saw; Machine Storage; Maintenance; Tips And Tricks - MacMah MJ2325A Owner's Manual

Danger!
–Do not extent the arbor nut wrench.
–Do not tighten arbor nut by tapping on the wrench
–After tightening the arbor nut do not forget remove
the saw spindle lock bar!
–Fixing of saw blade to spindle.
–When the spindle diameter is less than the saw
blade bore diameter,flanged bushed provided by
the machine manufacturer should be used to make
up the difference.The use of loose rings or bushes
is not permitted.
11. Loosen screw (a) of the riving knife bracket..
12. Adjust the distance between the saw blade's outer
edge and the riving knife(b). it must be 3-8mm.
13. Reinstall the throat plate and blade guard.
Slot for the saw blade in the table.
The total width of the slot for the saw blade is
12mm. the tilting direction is opposite to the
ordinary item. so the distance between the fixed
saw flange and the edge of the table slot is 8mm.
Selection of saw blade and riving knife.
The range of saw blade diameters and thickness
is below:
Saw blade diameter: 254mm
Saw blade thickness: 3mm
The operator should only select saw blade of a
diameter and thickness suitable for the machine.as
specified in the instruction handbook.
Selection of the riving knife is dependent on the
saw blade thickness and saw blade diameter. The
operator shoulld ensure that the riving knife
selected is suitable for the saw blade being used.
The riving knife-guiding slot should be no more
than 0.5mm wider than the riving knife guiding
elements.

10.2 Cleaning the saw

1. Lay machine on its side.
2. Remove chips and saw dust with vacuum cleaner
or brush;
– from saw blade setting guide elements
– from traveling sizing table guide elements
– from motor vent slots

10.3 Machine storage

Danger!
Store saw so that
it can not be started by unauthorized persons
–
nobody can get hurt.
–
Caution!
Do not store saw unprotected outdoors or in damp
environment.

10.4 Maintenance

Before switching on
Visual check if distance saw blade- riving knife is
3-8mm.Visual check of power cable and power cable
plug for damage; if necessary have damage parts
replaced by a qualified electrician.

1. Tips and Tricks

1
·Before cutting a work-piece to size make trial cuts
with pieces of scrap.
·Always place a word-piece on the saw table in such
way that it can not tilt or rock (e,g,always place a
curved board on the table with the convex side up).
·When working long stock use suitable supports, such
as table rear or side extensions(optional accessories).
·Keep surfaces of saw table and saw base clean – in
particular, remove resin residue with a suitable cleaning
and maintenance spray.

12. Repairs

Danger!
Repairs to electric tools must be carried out by
qualified electricians only!
Electric tools in need of repair can be sent to the
service centre of your country.
Refer to the spare parts list for the address.
Please attach a description of the fault to the electric
tool.