Initial Operation - MacMah MJ2325A Owner's Manual

Height hand-wheel for setting the depth of cut
The depth of cut can be adjusted by turning the
hand-wheel
Bevel hand-wheel for blade tilt setting
With the handwheel (d) the saw blade can be
steplessly tilted to the right from 0°(vertical) through
45°
Rip fence
The rip fence slides on the saw table's front rail and
rear rail.
Adjusting the miter gage
You can set the mitre gage at 0° and plus or minus
45° with the mitre gage stop pin and adjustable stop
screws.
Note: the mitre gage provides close accuracy in
angled cuts.For very close tolerances,test cuts are
recommended.
·Loosen knob and pull out on stop pin to rotate
mitre gage base past atop screws.
·Loosen the lock nut of the 0° stop screws at
the stop pin with an 8 mm wrench.
·Place a 90° square against the mitre gage rod
and the mitre gage base.
·If the rod is not square,loosen the knob, adjust the
rod,and tighten the knob.
·Adjust the 0
stop screw until it rests against the stop
°
pin.
·Adjust the plus and minus
triangle and the steps above.

8. Initial Operation

Caution:
Before changing the fuse, you must make sure the power
cable be unplugged in order to avoid injury.
8.1 Assembling the box stand
Unpacking the master carton,take off the plastic foam and
find four pieces stand panels, four stand level feet and a
bag of hardware.
Note:
Remaining hardware from this bag is used for assembly
box stand.
Use 8-M8 12 hexagon head bolt with 16-
×
nut tighten the front panel and side panel, then tighten the
rear panel and side panel.
Place 4-stand level foot on the down side of stand. then
also use 8-M8 12 hexagon head bolt with 16-
×
8-M8 nut tighten the stand and level foot.
stop screws using a
45°
8 washer,8-M8
￠
8 washer,
￠
45°