MacMah MJ2325A Owner's Manual page 16

Problem
Table saw does not start.
Power Switch does not
operate.
Fuses or circuit breakers open
frequently.
Motor stalls ,blows fuses, or
trips circuit breakers.
Table Saw is noisy when
running.
Warning: To prevent personal injury and/or damage to the table saw, maintenance and repairs should be done
only by a qualified technician.
Trouble Shooting Guide
Cause
Motor Cord is not plugged in.
Circuit fuse is blown.
Circuit breaker is tripped.
Motor Cord or Switch is damaged.
Power Switch contacts are burned out.
Capacitor is defective.
Wiring connections are loose or
damaged.
Motor is overloaded.
Fuses or circuit breakers are wrong size
or defective.
Dull 10" saw blade.
Power Switch is defective.
Motor is overloaded.
Dull 10" Saw Blade.
Fuses or circuit breakers are wrong size
or defective.
Feeding word-piece too rapidly.
Motor is loose or defective.
Solution
Plug in Motor Cord to volt electrical
outlet.
Replace circuit fuse.
Reset circuit breaker.
Have the Motor Cord or Switch
replaced.
Have the Power Switch replaced.
Request a voltage check from the local
power company.
Have the Capacitor replaced.
Have the wiring connections checked/
repaired.
Feed work-piece more slowly.
Replace fuses or circuit breakers.
Replace the 10" saw blade.
Have the Power Swith replaced.
Request a voltage check from the local
power company.
Replace the 10" saw blade.
Replace fuses or circuit breakers.
Feed work-piece into 10" Saw Blade
more slowly.
Have the Motor checked/repaired