Installing The Extension Table; Installing The Front Rail - MacMah MJ2325A Owner's Manual

Waring:
Do not lift the saw until without help.
The saw table is too heavy to lift without help,
customer should seek assistance from staff to lift
this item.

8.2 Installing the extension table

Warning:
Installing the extension table needs another
man's help.
1. Take off the extension table from the major case,put
4-M8×20 hex head screws with 4-8mm washer in
the holes of the right major table and extension
s
table,so the screw head extend outward 10mm.
2.Lift the extension table slightly and sure four screws up
on holes of major table.
3.Center the extension table over the edges and tap
it, check the surface alignment.
4.Tighten 4-screws with a 12mm wrench.

8.3 Installing the front rail

Warning:
The front and rear rails must be carefully aligned to
reduce the risk of kickback, which can cause serious
injury.
From the only carton take out the front rail with a plastic
bag in which you can find the following parts be used on
front rail.
Right and left end cap
6-tapping screw ST3.9×12
Locate the following hardware from a hardware bag in the
major case:
4-square head bolt M8×25
4-8mm flat washer
4-M8 hex nuts
1. Insert the 4 square head bolts into the table and
extension,so the bolt heads extend out 6mm.
2. Loosely attach a flat washer and a hex nut to each
bolt.
3. Slide the slot on the front rail over bolts, adjust each
bolt to fit the rail closely to the table.
4. push the front rail against table and hand tighten
each hex nut.
Note:
Make sure there are no gaps between the rail and edge of the
table or extension.