Advertisement
ASSEMBLY
ASSEMBLY OF RECOVERY TANK
AND SOLUTION
TANK
See Figure 2
1. Place Recovery Tank into Solution Tank (align the
word "VACUUM"
on Recovery Tank with =VACUUM"
on Solution Tank) and secure with Metal Latch.
2, Insert the plug onthe Short Cord from the Solution Tank
into the Recovery Tank Power Head.
ASSEMBLY OF HOSE, WANDS,
NOZZLE AND SOLUTION
TUBING
See Figure I
1. Assemble the two Straight Wands.
2. Assemblethe upper Straight Wand tothe Angled Wand
of the Hose.
3. Assemble the Floor Nozzle to the lower Straight Wand,
NOTE: Be sure locking button engages properly when
assembling straight wands, angled wand, and floor
nozzle.
4, Push the Solution Tube Quick-Disconne= Nut onto
Tdgger Valve. Twist clockwise to lock. See DETAIL ",4"
-Fig. 3.
5. Snap Solution Tubing into Retaining Clips on the
Angled Wand and Straight Wands. Connect other end
of Tubing to Carpet Tool,
6. Attach the Vacuum Hose to Recovery Tank inlet
(Vacuum Inlet).
7. Insert the Plastic Insert of the Solution Tubing into the
Coupling of the Solution Tank. See DETAIL "B"o Fig. 3.
NOTE: To remove the Plastic Insert depress the Tab
and gently pull on the Plastic Insert. Be careful to pull
on the Plastic Insert and not the Tubing as damage may
occur.
POWER
EAD
PLUG
SHORT
CORDIN
HERE
RECOVERY
TANK
SHORT
CORD
METAL
LATCH
TANK
Fig. 2
RETAINING
CLIP
INLET
PLASTIC INSERT
COUPLING
VACUUM
HOSE
TAB
DETAIL "B"
Fig, 3
Advertisement
