Setup Instructions; Attach To Borescope; Operating Instructions - General P16181HP User Manual

SETUP INSTRUCTIONS

ATTACH TO BORESCOPE

The probe is compatible with the following systems and components from
General:
• The DCS1600, DCS1600ART, DCS1700, DCS800, DCS1800 and DCS2000
Recording Video Borescope Inspection Systems
• The H16, H17, and H8 Handheld Recording Consoles (the DCS1600,
DCS1700 and DCS800 Systems without a probe)
• The DCS1800-TR Transmitting Probe Handle/Controller, which enables
video and images captured by the probe to be viewed on the console of a
DCS1800ART system
To attach the probe to any of the above systems, consoles or handle/controller,
retract the metal collar of the Probe connector (Fig. 1, Callout 10) to expose the
alignment key with a dot. Keeping the collar pulled back, align this dot with the
dot on the connector of your borescope, borescope console or handle/controller
and push the two connectors together. To secure the connection, push the
collar forward and turn it clockwise until tight.

OPERATING INSTRUCTIONS

For general guidelines on using the probe as an inspection tool, refer to the
Operating Instructions section of the user's manual for your borescope or
borescope console.
To adjust the intensity of the LEDs at the tip of the probe, roll the thumbwheel
on your borescope, borescope console or probe handle/controller forward or
back.
Because the VGA Resolution Probe has four extra-bright LEDs that require more
power than the LEDs of General's QVGA (320 x 240 pixel) resolution probes,
using the P16181HP, P16182HP or P16183HP will drain the batteries of your
borescope more quickly. You will have to recharge your borescope more often.
Remember to remove the red rubber protective cap from the tip of the probe
before using it.
5