Table of Contents
Advertisement
You can also use the anti-reflection function to remove glare created by the
probe's mirrored viewing tip (see the next section of this manual for installation
and alignment instructions). The pair of images below illustrates the net
positive effect.
MIRRORED VIEW
WITHOUT ANTI-REFLECTION
ATTACHING THE MIRRORED VIEWING TIP (OPTIONAL)
The only accessory included with the probe is a 110° mirrored viewing tip. To
attach it to the probe:
1. Pull off the red rubber protective cap (Fig. 1, Callout 5).
2. Unscrew and remove the black metal thread
protector ring (Callout 4), as shown at right.
3. Turn the stainless steel accessory alignment ring
(Callout 3) clockwise to move it away from the
probe tip. Keep turning until the ring can travel
no further.
4. Screw the mirrored viewing tip onto the camera
head (Callout 2) by turning it clockwise, as shown
at right. Keep turning until the viewing tip is as far
from the probe tip as possible. In this position, it
can rotate freely.
5. Press the
facing LEDs.
6. Slowly turn the mirrored viewing tip counterclockwise to move it toward
the probe tip. Once the threads of the tip grip the camera head, continue
turning only until the two LEDs are clearly visible through the gap in the
tip's housing.
button to activate the two-side
MIRRORED VIEW
WITH ANTI-REFLECTION
7
Advertisement
Table of Contents
