Setup Instructions; Activate Battery; Operating Instructions - General DAF3009 User Manual

SETUP INSTRUCTIONS

ACTIVATE BATTERY

1. Turn the meter over and use your thumbs or a coin to turn the
battery compartment cover on the back (Fig. 1, Callout F)
clockwise 30 degrees, in the direction marked OPEN.
2. Pull and discard the tab under the pre-installed battery.
3. Replace the battery compartment cover and turn it
counterclockwise 30 degrees until it snaps shut.
Complete Setup by carefully removing the plastic film protecting
the LCD.

OPERATING INSTRUCTIONS

To power on the DAF3009, press the red
illuminate with the backlight on and show all possible display
indications for 2 seconds. The unit will then automatically enter
the measurement mode in which it was operating when it
powered off. The backlight will turn off after 15 seconds if no
front-panel button is pressed during that period. Pressing any
button begins another 15 seconds of backlight.
To power off the DAF3009, press and hold the
least 2 seconds.
To change measurement mode, start by pressing the MODE button.
This will cause the icon of the current mode to begin flashing on
the top line. Then press the SET button one to three times, until the
icon of the mode you want begins flashing on the top line.
The figure below shows the four measurement modes in their
sequence of selection using the SET button.
VEL
6
button. The LCD will
button for at
RH BTU