Table of Contents
Advertisement
To change the setting, proceed as follows:
8. FM
Enable FM operating mode on the radio by repeatedly
pressing [mode]:
Alternatively, press [FM] on the remote control
to switch to this operating mode directly.
8.1 Search setting
The search setting allows you to determine whether
stations with low signal strength are ignored during the
automatic search.
Proceed as follows:
• To have the search stop only at stations with a strong
signal, select Only strong stations. Otherwise, the
search run will stop at every station for which a signal is
received.
[menu]
DRC
[mode]
[menu]
Scan setting
9
8.2 Automatic station search
• Press and hold [enter/navigate] until the automatic
station search starts.
• The radio stops the search and starts playback when it
finds a station.
• Press [enter/navigate] to continue the search until the
next station is found.
8.3 Manual station search
When you make station settings manually, you can define
the desired frequency yourself and tune into stations that
were ignored during the automatic station search because
their signals were too weak.
• Turn [enter/navigate] (left: - 0.05 MHz/ right: + 0.05)
until you see the desired frequency. Wait a moment until
playback of the received station signal begins.
8.4 Favourites
You can save up to 10 of your favourite stations for quick
and direct access.
8.4.1 Saving favourites
• Set the station that you would like to save as a favourite
station preset.
• When the station is displayed, press and hold [memory]
on the front of the radio.
After approx. 2 seconds, an overview window with the
favourites slots opens.
• Turn [enter/navigate] to switch between the slots (1 to
10).
• Press [enter/navigate] to store the station in the desired
favourites slot.
[memory]
Advertisement
Table of Contents
