Graco 960P Instruction Manual page 6

Fill Cup or Remote Pressure Pot
Spray Gun Cup
WARNING
The spray gun cup is pressurized by the gun's air
supply. To reduce the risk of serious injury from
pressurized fluid or accidental spray from the gun,
always turn off the air supply to the gun before
removing the spray gun cup.
Fill cup 3/4 full to keep air pressure tube clean. Install
cover. Under-cup cover has latch (H) to secure it to
cup. Over-cup has ring with notches (J) that secure
cup hood when locked in place on cup.
H
05292A
Fig. 3
Accessory Remote Pressure Pot
WARNING
The accessory remote pressure pots remain
pressurized until pressure is manually relieved. To
reduce the risk of serious injury from pressurized
fluid or accidental spray from the gun, always
relieve pressure in the pressure pot before
loosening or removing the cover.
1. Relieve remote pot pressure as follows:
a. Turn off air supply to pressure pot. See Fig. 4.
1
b. 2 / -gallon remote pressure pot:
2
Pull pressure relief valve ring (206c) until
pressure is completely relieved.
2-quart remote pressure pot:
Turn out pressure relief knob (113) one turn.
Wait until pressure is completely relieved
before removing cover. Close knob.
6 308336
Setup
1
/
2 gallon
2
Fig. 4
2. Remove pressure pot cover and fill. Secure cover.
J
NOTE: 2-quart remote pressure pot only:
Lightly coat cover threads with petroleum jelly.
If the 2-quart remote pressure pot is accidentally
05292
tipped over or held at too great of an angle, fluid
may leak into the air regulator and cause damage.
Take precautions to avoid this. If fluid does get into
the regulator, clean immediately.
Do not tighten the pressure pot cover more than
hand-tight. Excessive tightening may damage the
cover gasket.
113
206c
02860
CAUTION
CAUTION
2 quart
02882