Table of Contents
Advertisement
3. Fully insert needle assembly (14) into back of fluid
manifold (6).
4. Perform needle adjustment procedure steps 2 thru
5 of Adjusting Needle on page 16.
5. Perform needle packings adjustment procedure
steps 4 thru 8 of Adjusting Needle Packings on
page 16.
Prepare 960 Cup Gun for Pressure Feed
1. Remove air pressure tube (34) from air stem (33).
See parts drawing on page 20.
2. Hold fluid inlet fitting (7) with wrench and remove
cup assembly (59).
3. Remove air stem (33) from gun body (1).
4. Apply medium strength threadlocker to set screw
(61) and assemble to gun body.
25
27
29
Fig. 2
Setup
6
Prepare Fluid
1. Always strain fluid before spraying; this includes
color, reducer, and hardeners.
2. Use slower drying reducer or thinner to compen-
sate for faster drying time from warm turbine air.
Do not over reduce.
Paint Reduction — Automotive Type Finishes
Reduce and catalyze all paint to manufacturer's
specifications. Compensate for faster turbine drying
time by using reducer one-step slower than
conventional air spray.
Paint Reduction — Industrial or Domestic
Coatings
Reduce and catalyze all paint to manufacturer's
specifications. If no reductions are given, first
thoroughly mix fluid to be sprayed. Gradually mix in
reducer, testing fluid for correct spraying consistency.
Test consistency, remove stir stick from thinned paint.
Consistency is right when first drops from stir stick are
about one second apart.
22
23
20
21
14
05289
308336
5
Advertisement
Table of Contents
