Chapter 2 Installing Your Product; Plugging In Signals; Plugging In Main Power; Turning On Your Product - RGBlink VENUS X2 User Manual

Chapter 2 Installing Your Product

2.1 Plugging in Signals

Connect signals to the product (ensure all devices are powered off first). Tighten connector
screws/locks where provided.
For connector protection and for additional cable support this product is fitted with protection
frames on either side of the device. For cable support use cable ties to attached to the protection
frames to avoid stress on signal connectors.

2.2 Plugging in Main Power

Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.

2.3 Turning on Your Product

The device will enter to the boot interface, and OLED display will show as below, completing
initialization before loading last settings and input/output configuration.
On delivery, the output format is defaulted to 1920x1080x60.
VENUS X2 User Manual 11