Set The Foot Control; Check Your Feed Balance Dial; Set The Pressure Dial - Kenmore 385. 19601 Owner's Manual

SECTION 2. PREPARE YOUR MACHINE FOR SEWING
Set Up the Machine {Continued)
Set the Foot Control @ Check Your Feed {3alance Dial
= Set the Pressure Dial
J
The foot control reguIales the speed at
which you sew,
Position the foot control as shown_ with
your heel on tile floor.
To increase speed, gently press down with
tile ball of your _ooL
To decrease speed, release your tOOl pressure
slightly,
NOTE: The tOOt control Is sensitive and
will increase or decrease your
sewing speed immediately. Practice
on a scrap of fabric to regulate your
sewing speed to your taste and
needs+
For most sewing, the groove in the Feed
Balance Dial should point to the arrow
l °"D"i,
Yoy may rarely need to adjust _he dial. But,
if necessary, use this dial to regulate the teed
balance tot:
* Automatic Darning {See p. 68 for details}
• Buttonholes {See p. 73fordetai{s)
• Any *'stretch" stitch such as patterns
[] and monogramming when sewing
on Spemal fabrtcs.
dial
The pressure control dial is {oeated inside the race Cover plate,
Set the dial aligning the setting mark on the dial with the groove
as tullowso
3 .... most sewing
2 .... applique and Cut-Out work
.... sewing chiffon, lace, organdy and other lightweight
fabrics. Also for velours and kn_ts twith more stretch)
0 .... basting, manual darning and embroidery
NOTE: The pressure dial should be reset at 3 after changing
pressure, so the machine is ready for most normal
sewing the next lime you use it.