Prepare The Bobbin; To Remove; Wind The Bobbin - Kenmore 385 Owner's Manual

Prepare the Bobbin
• To Remove the Bobbin from the Machine
1 Gently push down on the bobbin cover plate and slide
it towards you.
2. Set aside.
3. Lift c)ut the bobbin, as shown.
SECTION !2; _PREPARE YOUR MACHINE FOR SEWING
• Wind the Bobbin
Bobbin windingspindle
1. Put your spool of thread onto spool pin. with the thread winding in the direction
shown.
2. Pull the clutch away from the machine to stop the needle from moving while you
winding the bobbin.
3. Draw thread from spool through bobbin winder tension disc as shown,
4. Place the threaded bobbin on the bobbin winding spindle so that the thread comes
out on top.
5. Push the bobbin winder spindle to the right until it clicks.
6, Holding onto end of thread, depress the foot control.
7. When the bobbin is slightly filled, stop the machine and clip the thread coming from
the bobbin.
8. Slowly start the machine again and wind the thread until the bobbin stops.
9. Push the bobbin winder spindle to the left and clip the thread.
10. Remove the bobbin.
1 I. Push in the clutch for normal sewing operation.
15