Table of Contents
Advertisement
6. Make sure the battery is completely lowered into the compartment before letting go the
Battery Release Slider. Battery will be flat against the housing once fully inserted.
7. Reinsert the battery by latching the bottom first (1) and then pushing the battery pack down
(2).
Caution
Do not insert your fingers into contact hole when inserting the battery.
Check the battery latch:
Removing the Battery Pack:
1.
Power off the PDA. Disconnect any cords connected to the device.
2.
Turn the PDA over, back facing up.
Locate the Battery Lock Latch and push it to the "Unlocked" position.
3.
4.
Locate the Battery Release Slider that is spring-loaded. Pull back and hold.
5.
Lift the battery out using the opening on side of battery compartment.
Chapter 1: Getting Started
21
Advertisement
Table of Contents
