Craftsman 113.2433 Owner's Manual page 10

assem61y
7. Install the small pulley ontothe motor shaft and tighten
the se_ screw _n the pulley hub against the flat part of
the motor shaft,
SMALL [2-9/2" DIA,) MOTOR PULLEY
5/32 INCH
SETSCREW
WRENCH
\
\
\
TIGHTEN
SET SCREW
AGAINST FLAT
ON SHAFT
8. Push V-Belt partly through belt guard enough to allow
belt to loop around the large pulley and push guard ove r
belt and pulley into position on guard support
-1
\
OPEN END
9. Push the lower section of the V-Belt through theother
guard as in the previous step and loop V-Belt around
small pulley on motor shaft,
10. Visually line up both pulleys and V-Belt until they are
perpendicular to the floor by sliding motor sideways as
needed.
1 1. Press clown hard on motor to put tension on the V-Bell
and tighten the motor mounting bolts at this time.
12, Check guard support before tightening guard support
screws to be su re tt is centered around motor shaft and
will not rub against shaft when motor =s running
Tighten screws.
13. Push motor pulley belt guard into position onto guard
support.
/
PULLEY FLUSH
HERE WITH
MOTOR SHAFT
/
/
,/
I
SAW --
!
i/
#
I
t
PULLEYS AND V-BELT
MUST BE STRAIGHT IN-LINE
_AT90' WITH RELATIONSHIP
TO THE FLOOR
_V-BELT
---7
t GUARDS REMOVED
"_ _ FOR PICTURE CLARITY
\\'
\ t
,_ STRAIGHT LINE
\ _ UP -- DOWN
90° I _ /
10