Craftsman 113.2433 Owner's Manual page 9

4. Place the large pulley onto the drive wheel shaft and
insert the key into the keyway of the shaft and pulley.
Position pulley hub flush with end of shaft and tighten
set screw securely against key.
Ilil i
HUB SET SCREW
_" FLUSH HER£ !
3/16" KEY
KEYWAY iN SHAFT
AND PULLEY
/ LOCKWASHER
FLAT WASHER
-NUT
5. Place motor against the motor mounting bracket and
insert bolts through holes in motor base and then
through holes marked "'X" in motor mounting bracket.
DO NOT TIGHTEN BOLTS AT THIS TIME. The "'L'"
bracket which holds the guard support must be slid
between the motor base and the motor mounting
bracket so motor must be loosely assembled to bracket
at this time.
CARRIAGE BOLT
5/16-18 x 3/4
MOTOR
VIEW FROM BACK OF SAW.
BOLTS GO THRU HOLES MARKED"X"
" /i
6, Slide long leg of "'L'" bracket between motor base and
motor mounting bracket. Then sandwich the "L"
bracket between the guard support bracket and the
guard support and loosely fasten together with self-
threading screws as shown. Install clips onto belt
guard support.
:"L" BRACKET
TWO HOLES CLOSEST
TOGETHER
J
BELT GUARD I
SUPPORT BRACKE"
10-32 X 1/;= IN,
""" SEL'F-THREADING
SCREW
BELT GUARD !i
SUPPORT