Graco DataTrak kit Instructions And Parts page 11

Replace DataTrak Battery or Fuse
To reduce the risk of fire and explosion, the battery
and fuse must be replaced in a non-hazardous loca-
tion.
Use only an approved replacement battery, shown in
Table 2, and an approved fuse, shown in Table 3. Use
of an unapproved battery or fuse will void Graco's war-
ranty and Intertek and Ex approvals.
Replace Battery
1. Unscrew cable from the reed switch assembly. See
Fig. 2.
Fig. 2. Disconnect DataTrak
2. Remove DataTrak module from bracket. See Fig. 3.
Take module to a non-hazardous location.
Fig. 3. Remove DataTrak
313840N
3. Remove two screws on back of module to access
battery.
4. Disconnect the used battery and replace with an
approved battery. See Fig. 4.
Table 2. Approved Batteries
Energizer alkaline # 522
Varta alkaline # 4922
Ultralife lithium # U9VL
Duracell alkaline # MN1604
ti14053a
DataTrak Operation
11