Ce Declaration Of Conformity - EMS EnviroStart Installation & Commissioning Manual

2.1

CE DECLARATION OF CONFORMITY

MANUFACTURERS DECLARATION OF CONFORMITY
This declaration covers all EnviroStart SPMEC Control units.
This product fulfils the following European Community Directives when applied as
follows:
Low Voltage Directive
The above products fulfil the Low Voltage Directive 73/23/EEC, 89/336/EEC and
93/68/EEC amendment for industrial equipment; however, they must be installed to
general good electrical engineering practices and regulations by a suitably
qualified person with strict reference to the instructions in the product's Technical
Manual.
EMC Directive
The above products are intended to be a component in a system or a machine.
They must be mounted into an appropriate enclosure and system designed to fulfil
the CE directives plus IEC and local industrial standards. Units must be installed by
a suitably qualified person to comply with general good electrical engineering
practices and regulations with strict reference to the instructions in the product's
Technical Manual. To meet all EMC directives, the above products are available
with an optional RFI Filter.
IEC-1000-4-2 Level 3; IEC-1000-4-3 Level 3; IEC-1000-4-4 Level 4; IEC-1000-4-5
Level 3; IEC-1000-4-12 Level 3.
The above is based on test results from an independent test laboratory (Steatite
Group Ltd.) to test specification EN 50081-2, EN 50082-1 and EN 50082-2.
Harmonised Standards Applicable
BS EN 6094.4.4 (which calls on EN 56011); EN 55022; EN 51000.4.2;
EN 61000.4.3; EN 51000.4.4; EN 61000.4.5; EN 61000.4.6; EN 61000.4.8;
EN 6094.4.2;
EN 61000.4.11; BS EN 50081.1; BS EN 50081.2; BS EN 50082.2;
IEC-947-4-1; IEC-68-2-6, (NFC2076; BV1); IEC-947-4-2.
EN 60439; EN 60831.1, EN 60831.2, EN 61921.2003
Electrical Requirements Specification G5/4 - 2 (2008)
Dated: September 2009
Single Phase Motor Energy Control - Page 6 of 20